with apologies to Ogden Nash...
Does its no-namedness suggest that it came as an ancillary included with a lathe or mill? Or is that too big a leap for quality speculating?
that was an awesome realization.
How's it held onto the mill bed? D.
I really don't know. It looks turn-of-the-last-century old, the base is definitely part of the unit but there is no obvious method of fastening it to anything.
Obviously this is not a vise but it's a good picture of the type of clamp that might be used to hold it down:https://f.hubspotusercontent00.net/hubfs/2877253/Imported_Blog_Media/KurtOutsideJaws.jpgUsed correctly those clamps can apply some serious holding power.
Post a Comment
5 comments:
Does its no-namedness suggest that it came as an ancillary included with a lathe or mill? Or is that too big a leap for quality speculating?
that was an awesome realization.
How's it held onto the mill bed? D.
I really don't know. It looks turn-of-the-last-century old, the base is definitely part of the unit but there is no obvious method of fastening it to anything.
Obviously this is not a vise but it's a good picture of the type of clamp that might be used to hold it down:
https://f.hubspotusercontent00.net/hubfs/2877253/Imported_Blog_Media/KurtOutsideJaws.jpg
Used correctly those clamps can apply some serious holding power.
Post a Comment